Danfoss FC 300

If the selected parameter is a text value,
change the text value by means of the [▴]
[▾] navigation keys.
The up key increases the value, and the down
key decreases the value. Place the cursor on
the value you want to save and press [OK].
130BP068.10
2.1.13. Changing a Group of Numeric Data Values
If the chosen parameter represents a numeric
data value, change the chosen data value by
means of the [◂] [▸] navigation keys as well
as the [▴] [▾] navigation keys. Use the [◂]
[▸] navigation keys to move the cursor hori-
zontally.
130BP069.10
Use the [▴] [▾] navigation keys to change the
data value. The up key enlarges the data val-
ue, and the down key reduces the data value.
Place the cursor on the value you want to save
and press [OK].
130BP070.10
2.1.14. Infinitely Variable Change of Numeric Data Value
If the chosen parameter represents a numeric
data value, select a digit by means of the [◂]
[▸] navigation keys.
130BP073.10
Change the selected digit infinitely variably by
means of the [▴] [▾] navigation keys.
The chosen digit is indicated by the cursor.
Place the cursor on the digit you want to save
and press [OK].
130BP072.10
FC 300 Programming Guide 2. How to Programme
MG.33.M2.02 - VLT
®
is a registered Danfoss trademark 21
2