Danfoss FC 300

1.1.3. Abbreviations
Alternating current AC
American wire gauge AWG
Ampere/AMP A
Automatic Motor Adaptation AMA
Current limit I
LIM
Degrees Celsius °C
Direct current DC
Drive Dependent D-TYPE
Electro Magnetic Compatibility EMC
Electronic Thermal Relay ETR
drive FC
Gram g
Hertz Hz
Kilohertz kHz
Local Control Panel LCP
Meter m
Millihenry Inductance mH
Milliampere mA
Millisecond ms
Minute min
Motion Control Tool MCT
Nanofarad nF
Newton Meters Nm
Nominal motor current I
M,N
Nominal motor frequency f
M,N
Nominal motor power P
M,N
Nominal motor voltage U
M,N
Parameter par.
Protective Extra Low Voltage PELV
Printed Circuit Board PCB
Rated Inverter Output Current I
INV
Revolutions Per Minute RPM
Second s
Torque limit T
LIM
Volts V
1.1.4. Definitions
Drive:
D-TYPE
Size and type of the connected drive (dependencies).
I
VLT,MAX
The maximum output current.
I
VLT,N
The rated output current supplied by the frequency converter.
U
VLT, MAX
The maximum output voltage.
Input:
Control command
You can start and stop the connected motor
by means of LCP and the digital inputs.
Functions are divided into two groups.
Functions in group 1 have higher priority than
functions in group 2.
Group 1 Reset, Coasting stop, Reset
and Coasting stop, Quick-stop,
DC braking, Stop and the "Off"
key.
Group 2 Start, Pulse start, Reversing,
Start reversing, Jog and
Freeze output
1. Introduction FC 300 Programming Guide
4 MG.33.M2.02 - VLT
®
is a registered Danfoss trademark
1