Danfoss PLUS+1 Series User Manual

General Comments
Mating Connectors
PLUS+1 modules use Deutsch® connectors. Danfoss has assembled a mating connector kit, referred to as
a bag assembly, for the 12, 24, 38, 50, and 88 pin module housings. Mating connector bag assembly
ordering information is found in the product data sheet for each module.
Deutsch Mating Connector Part Information
Description 12 pin
module
18 pin
module
24 pin
module
38 pin
module
50 pin
module
88 pin
module
Crimp tool HDT48-00(soli
d contacts)(20
to 24 AWG)
HDT48-00(soli
d contacts)(16
to 20 AWG)
HDT48-00(soli
d contacts)(20
to 24 AWG)
— — HDT48-00(soli
d contacts)(20
to 24 AWG)
HDT48-00(soli
d contacts)(20
to 24 AWG, 12
to 14 AWG)
DTT20-00(stam
ped contacts)
(16 to 20 AWG)
DTT20-00(stam
ped contacts)
(16 to 20 AWG)
DTT20-00(stam
ped contacts)
(16 to 20 AWG)
DTT20-00(stam
ped contacts)
(16 to 20 AWG)
Contacts Solid:
0462-201-2031
(20 to 24 AWG)
Solid:
0462-201-163
1(16 to 20
AWG)
Solid:
0462-201-2031
(20 to 24 AWG)
Stamped:
0462-203-1214
1(10 to 14
AWG)
1062-20-0144(
16 to 20 AWG)
Solid:
0462-201-2031
(20 to 24 AWG)
Solid:
0462-201-2031
(20 to 24 AWG)
Stamped:
1062-20-0144
(16 to 20 AWG)
Stamped:
1062-20-0144(
16 to 20 AWG)
Stamped:
1062-20-0144(
16 to 20 AWG)
Solid:
0462-201-1214
1 (12 to 14
AWG)
Stamped:
1062-20-0144(
16 to 20 AWG)
Connector
plug
Gray A-Key
DTM 06-12SA
DT16-185B-
K004
Gray A-
KeyDTM
06-12SA Black
B-Key DTM
06-12SB
DRC26-38S01-
P017
DRC26-50S01 DRC26-50S01D
RC26-38S01-
P017
Wedge WM-12S Not required WM-12S Not required Not required Not required
Strip length 3.96 to 5.54
mm[0.156 to
0.218 in]
6.35 to 0.792
mm[0.250 to
0.312 in]
3.96 to 5.54
mm[0.156 to
0.218 in]
6.43 to 0.79
mm[0.253 to
0.031 in]
3.96 to 5.54
mm[0.156 to
0.218 in]
20 to 24 AWG:
3.96 to 5.54
mm[0.156 to
0.218 in]
12 to 14 AWG:
6.43 to 0.79
mm[0.253 to
0.031 in]
Rear
sealmaximum
insulation OD
3.05 mm
[0.120 in]
3.05 mm
[0.120 in]
3.05 mm
[0.120 in]
4.32 mm [0.17
in]
2.41 mm
[0.095 in]
20 to 24 AWG:
2.41 mm
[0.095 in]
12 to 14 AWG:
4.32 mm [0.17
in]
Sealing plugs 0413-204-2005 114017 0413-204-2005 114017 0413-204-2005 0413-204-2005
, 114017
Technical Information PLUS+1® Controller Family
Product Installation and Start-up
520L0719 • Rev PB • Feb 2014 27

Danfoss PLUS+1 Series Specifications

General

Temperature Range	-40°C to +85°C
Ingress Protection	IP67
Communication Interfaces	CAN, Ethernet, USB, RS232, RS485
Operating System	PLUS+1 GUIDE
Programming Language	PLUS+1 GUIDE (Graphical User Integrated Development Environment)
Memory	Flash, RAM
Inputs	Analog, Digital
Outputs	PWM, High-Side
Protection	Overvoltage, Undervoltage, Reverse Polarity, Short Circuit
Operating Voltage	8-32 VDC