•
The engine should be off.
•
Disconnect the negative battery cable from the battery.
•
Do not use electrical components to ground the welder. Clamp the ground cable for the welder to
the component that will be welded as close a possible to the weld.
PLUS+1 USB/CAN Gateway
Communication (software uploads and downloads and service and diagnostic tool interaction) between
PLUS+1 modules and a personal computer (PC) is accomplished using the vehicle’s PLUS+1 CAN
network.
The PLUS+1 CG150 USB/CAN gateway provides the communication interface between a PC USB port and
the vehicle CAN bus. When connected to a PC, the gateway acts as a USB slave. In this configuration, all
required electrical power is supplied by the upstream PC host. No other power source is required.
Refer to the PLUS+1 GUIDE Software User Manual, literature number 10100824, for gateway set-up
information. Refer to the CG150 USB/CAN Gateway Data Sheet, literature number 520L0945, for electrical
specifications and connector pin details.
Technical Information PLUS+1® Controller Family
Product Installation and Start-up
30 520L0719 • Rev PB • Feb 2014
To Next Page
Loading...
