4. If thick cables are used, put the cable insulators in between the terminals to prevent contact between the cables.
5. Connect the cables. See the correct tightening torques in 10.5 Tightening Torques of the Terminals.
A Connect the phase conductors of the mains cable and of the motor cable into the correct terminals. If a brake resistor cable is
used, connect its conductors into the correct terminals.
B Attach the grounding conductor of each cable to a grounding terminal with a grounding clamp for grounding conductor.
C Make sure that the external grounding conductor is connected to the grounding bar. See
6.3 Grounding.
Electrical Installation
Operating Guide | VACON® 100 Wall-mounted Drives
AQ298036140958en-000101 / DPD01711
50 | Danfoss A/S © 2019.05
To Next Page
Loading...
