1.12.3 Manual Initialisation 24
1.12.4 Display Readout States 24
1.12.5 Hand Auto 25
1.12.6 Automatic Motor Tuning 25
1.13 LCP 2 Control Unit
26
1.13.1 Introduction 26
1.13.2 Control Keys for Parameter Set-up 26
1.13.3 Indicator Lights 27
1.13.4 Local Control 27
1.13.5 Displayed Data Items 28
1.13.6 Display Modes 28
1.13.7 Parameter Set-up 29
1.13.8 Quick Menu with LCP 2 Control Unit 29
1.13.9 Parameter Selection 30
1.13.10 Manual Initialisation 31
2 Safety
32
2.1 Safety Symbols
32
2.2 Qualified Personnel
32
2.3 Safety Precautions
32
3 Installation
34
3.1 Mechanical Dimensions
34
3.1.1 Overview 34
3.1.2 Enclosure B 34
3.1.3 Enclosure C 34
3.1.4 Enclosure D 35
3.1.5 Motor Coils (195N3110) 35
3.1.6 RFI 1B Filter (195N3103) 35
3.1.7 Terminal Cover 35
3.1.8 IP21 Solution 36
3.1.9 EMC Filter for Long Motor Cables 37
3.2 Mechanical Installation
38
3.3 Electrical Installation
39
3.3.1 High Voltage Warning 39
3.3.2 Grounding 39
3.3.3 Cables 39
3.3.4 Screened/armoured Cables 40
3.3.5 Extra Protection 40
3.3.6 High Voltage Test 40
3.3.7 EMC-correct Electrical Installation 41
Contents Design Guide
2 Danfoss A/S © Rev. May/2014 All rights reserved. MG27E402
To Next Page
Loading...
