Danfoss VLT AutomationDrive FC 300 User Manual

4.6.6 Shielded Cables 45
4.6.10 Load Sharing 46
4.6.11 Mains Connection 46
4.6.12 External Fan Supply 47
4.6.13 Power and Control Wiring for Unscreened Cables 47
4.6.14 Fuses 47
4.6.20 Control Cable Routing 50
4.6.22 Electrical Installation, Control Terminals 51
4.7 Connection Examples for Control of Motor with External Signal Provider
52
4.7.1 Start/Stop 52
4.7.2 Pulse Start/Stop 53
4.8 Electrical Installation - Additional
54
4.8.1 Electrical Installation, Control Cables 54
4.8.2 Switches S201, S202, and S801 55
4.9 Final Set-up and Test
56
4.10 Additional Connections
57
4.10.1 Mechanical Brake Control 57
4.10.3 Motor Thermal Protection 58
5 How to Operate the Low Harmonic Drive
59
5.1.2 How to Operate Graphical LCP (GLCP) 59
6 How to Programme the Low Harmonic Drive
67
6.1 How to Programme the Frequency Converter
67
6.1.1 Quick Setup Parameters 67
6.1.2 Basic Setup Parameters 69
6.1.3.1 PTC Thermistor Connection 70
6.1.3.2 KTY Sensor Connection 71
6.1.3.3 ETR 71
6.1.3.4 ATEX ETR 72
6.1.3.5 Klixon 72
6.2 How to Programme the Active Filter
88
6.2.1 Using the Low Harmonic Drive in NPN Mode 88
6.3 Parameter Lists - Frequency Converter
90
6.4 Parameter Lists - Active Filter
125
6.4.1 Operation/Display 0-** 125
6.4.2 Digital In/Out 5-** 126
6.4.3 Comm. and Options 8-** 126
6.4.4 Special Functions 14-** 127
6.4.5 FC Information 15-** 128
6.4.6 Data Readouts 16-** 129
Contents VLT Automation Low Harmonic Drive Operating Instructions
2 MG34O202 - VLT
®
is a registered Danfoss trademark

Danfoss VLT AutomationDrive FC 300 Specifications

General

Brand	Danfoss
Model	VLT AutomationDrive FC 300
Category	DC Drives
Language	English