Danfoss VLT AutomationDrive FC 300 User Manual

6.4.7 AF Settings 300-** 130
6.4.8 AF Readouts 301-** 131
7 RS-485 Installation and Set-up
132
7.1.2 EMC Precautions 133
7.2 Network Configuration
133
7.2.1 Set-up 133
7.3 FC Protocol Message Framing Structure
133
7.3.1 Content of a Character (byte) 133
7.3.2 Telegram Structure 133
7.3.3 Telegram Length (LGE) 134
7.3.4 Frequency Converter Address (ADR) 134
7.3.5 Data Control Byte (BCC) 134
7.3.6 The Data Field 134
7.3.7 The PKE Field 135
7.3.8 Parameter Number (PNU) 136
7.3.9 Index (IND) 136
7.3.10 Parameter Value (PWE) 136
7.3.11 Data Types Supported by the Frequency Converter 136
7.3.12 Conversion 137
7.3.13 Process Words (PCD) 137
7.4 Examples
137
7.4.1 Writing a Parameter Value 137
7.4.2 Reading a Parameter Value 137
7.5 How to Access Parameters
138
7.5.1 Parameter Handling 138
7.5.2 Storage of Data 138
7.5.3 IND 138
7.5.4 Text Blocks 138
7.5.5 Conversion Factor 138
7.5.6 Parameter Values 138
8 General Specifications
139
8.2 Filter Specifications
146
9 Troubleshooting
147
9.1 Alarms and Warnings - Frequency Converter (Right LCP)
147
9.1.1 Warnings/Alarm Messages 147
9.2 Alarms and Warnings - Filter (Left LCP)
158
Index
164
Contents VLT Automation Low Harmonic Drive Operating Instructions
MG34O202 - VLT
®
is a registered Danfoss trademark 3

Danfoss VLT AutomationDrive FC 300 Specifications

General

Brand	Danfoss
Model	VLT AutomationDrive FC 300
Category	DC Drives
Language	English