VLT
®
AutomationDrive EtherNet/IP
MG.90.Jx.02 ver. 5
th
September 2007 – VLT is a registered Danfoss trademark 18
Under the Connection Tab, enter information about: RII and fault conditions.
The Module Info – tap holds generic information.
The Reset Module – button will make a simulated Power-cycle of the drive.
N.B.:
For more information on the CIP class 1 Forward Open command, please refer to section:
EtherNet/IP Connections under the How to Control -chapter.
To Next Page
Loading...
