Danfoss VLT AutomationDrive Manual

VLT
®
AutomationDrive EtherNet/IP
MG.90.Jx.02 ver. 5
th
September 2007 – VLT is a registered Danfoss trademark 59
Index
A
Abbreviations 6
AC/DC drive object 53
Alarm word 45-49
Appendix 50
Assembly object 50
Assembly instances 20
Assumptions 5
B
Background Knowledge 5
C
Cable length 10
Cabling 10
Change-Of-State 23
CIP objects 50
Class 1 connection 21
Class 3 connection 22
Configuration 14-19
Conversion index 44
Control supervisor object 52
D
Danfoss objects 58
Data types 43
E
EDS 17
EMC precautions 12
Ethernet 4, 14
EtherNet/IP 4, 14
F
FC profile 24
Forward Open 21
H
Hardware 5, 7
I
I/O 20
Identity object 50
IGMP 19
Installation 13
Interface object 54
IP settings 14
IP traffic 19
L
Link object 54
Literature 5
LEDs 8
M
Master 17
Motor data object 51
Multicast 19
N
Network 10
O
Object model 50
ODVA conformance 5
ODVA profile 28
Overview (technical) 5
P
Parameter access 58
Parameter group object 56
Parameter object 55
Parameters 32–42
R
Reference 30
Rockwell master 17
S
Safety 3
Spanning Tree 19
T
Topology 9
U
Unconnected message 22
W
Warning word 47-49

Danfoss VLT AutomationDrive Specifications

General

Supply Voltage	3 x 200-240 V ±10% 3 x 380-500 V ±10% 3 x 525-600 V ±10%
Enclosure	IP20
Output Power Range	0.25 kW - 1.5 MW
Communication Protocols	Modbus RTU
Protection Features	Overcurrent, Overvoltage, Undervoltage, Short circuit, Ground fault, Motor overload
Ambient Temperature Range	-10°C to +50°C (14°F to 122°F)