VLT
®
AutomationDrive EtherNet/IP
MG.90.Jx.02 ver. 5
th
September 2007 – VLT is a registered Danfoss trademark 2
Copyright, Limitation of Liability and Revision Rights
This publication contains information proprietary to Danfoss A/S. By accepting and using this manual
the user agrees that the information contained herein will be used solely for operating equipment from
Danfoss A/S or equipment from other vendors provided that such equipment is intended for
communication with Danfoss equipment over a Ethernet serial communication link. This publication is
protected under the Copyright laws of Denmark and most other countries.
Danfoss A/S does not warrant that a software program produced according to the guidelines provided
in this manual will function properly in every physical, hardware or software environment.
Although Danfoss A/S has tested and reviewed the documentation within this manual, Danfoss A/S
makes no warranty or representation, either express or implied, with respect to this documentation,
including its quality, performance, or fitness for a particular purpose.
In no event shall Danfoss A/S be liable for direct, indirect, special, incidental, or consequential
damages arising out of the use, or the inability to use information contained in this manual, even if
advised of the possibility of such damages. In particular, Danfoss A/S is not responsible for any costs
including but not limited to those incurred as a result of lost profits or revenue, loss or damage of
equipment, loss of computer programs, loss of data, the costs to substitute these, or any claims by
third parties.
Danfoss A/S reserves the right to revise this publication at any time and to make changes in its
contents without prior notice or any obligation to notify previous users of such revisions or changes.
To Next Page
Loading...
Need help?
General
