Danfoss VLT AutomationDrive - Page 42

VLT
®
AutomationDrive EtherNet/IP
- P a r a m e t e r s –
MG.90.Jx.02 ver. 5
th
September 2007 – VLT is a registered Danfoss trademark 42
(12-98) Interface Counters
Range:
In Octets [0]
In Unicast Packets [1]
In Non-Unicast Packets [2]
In Discards [3]
In Errors [4]
In Unknown Protocols [5]
Out Octets [6]
Out Unicast Packets [7]
Out Non-Unicast Packets [8]
Out Discards [9]
Out Errors [10]
Function:
Read only.
Advanced Interface counters, from build-in
switch, can be used for low-level trouble-
shooting,
The parameter shows a sum of port 1 + port 2.
(12-99) Media Counters
Range:
Alignment Errors [0]
FCS Errors [1]
Single Collisions [2]
Multiple Collisions [3]
SQE Test Errors [4]
Deferred Errors [5]
Late Collisions [6]
Excessive Collisions [7]
MAC Transmit Errors [8]
Carrier Sense Errors [9]
Frame Too Long [10]
MAC Receive Errors [11]
Function:
Read only.
Advanced Interface counters, from build-in
switch, can be used for low-level trouble-
shooting,
The parameter shows a sum of port 1 + port 2.