Danfoss VLT Micro Drive FC 51 - Main Menu

4.5. Main Menu
The Main Menu gives access to all parameters.
1. To enter the Main Menu, press
[MENU] key until indicator in display
is placed above
Main Menu .
2. Use [▲] [▼] to browse through the
parameter groups.
3. Press [OK] to select a parameter
group.
4.
Use [▲] [▼] to browse through the
parameters in the specific group.
5. Press [OK] to select the parameter.
6. Use [▲] [▼] to set/change the pa-
rameter value.
7. Press [OK] to accept the value.
8. To exit, press either [Back] twice to
enter
Quick Menu , or press [Menu]
once to enter
Status .
Illustration 4.10: Indicating Main Menu mode
4. Programming VLT Micro Drive FC 51 Operating Instructions
22 MG.02.A2.02 - VLT
®
is a registered Danfoss trademark
4