Danfoss VLT Safety Option MCB 150 - Page 71

Table 15: LCP Copy Messages
Message Description
e30bd114.11
Password
0-69 Password Protection
of safety Parameter
1(1)
0 RPM None
[1] Enabled
([0] Disabled)
The password protection of the safety parameters is enabled.
e30bd116.11
Copy/Save
0-50 LCP Copy
1(1)
0 RPM None
Safety Par. from LCP
0-5
*
9
[ ]
Copying the safety parameters from the LCP into the drive is selected.
e30bd117.11
Safety Par. from LCP
1(1)
0 RPM None
Copying...
00%
The safety parameters get copied from the LCP into the drive.
e30bd118.11
Safety Password
Please enter the safety
Password
1(1)
0 RPM None
00000000
If password protection is enabled in parameter 0-69 Password Protection of Safety Parameters, en-
ter the correct LCP-copy/parameter mismatch password (parameter 0-68 Safety Parameters Pass-
word).
e30bd119.11
1(1)
0 RPM None
Password accepted
Pa
0-
[0
([1] Enabled)
If the entered password is correct, this overlay message is shown for some seconds.
e30bd123.11
1(1)
0 RPM None
Password rejected
Pa
0-
[0
([1] Enabled)
If the entered password is wrong, this overlay message is shown for some seconds. Then the pass-
word can be entered again.
Service and Repair
Installation Guide | VLT® Safety Option MCB 150/151
AQ279747441421en-000101 / 130R0292 | 71
Danfoss A/S © 2018.09