60 Using Printer Manager
DPCL2Secure Enable or disable DPCL2 command access to the printer through the
secure port.
Default: Enabled
DPCLSecure Enable or disable DPCL command access to the printer through the
secure port.
Default: Enabled
Remake Enable or disable card remakes. If Remake is enabled and a print
request fails, the print request is tried again with a new card. A card
is retried only once.
Default: Enabled
RemakeMethod Select the card remake method. Choices are PreserveOrder (reprint
in queue order) or ConserveSupplies (reprint out of queue order).
This setting is ignored if Remake is set to Disabled.
Default: ConserveSupplies
RetrieveDataTimeout Specify the time period during which card data can be retrieved. You
can specify from 0 to 120 seconds. If the current value is 0, data is
not retrieved.
SmartcardForceProtocol The smart card reader normally auto-detects the protocol to use to
communicate with the smart card chip. However, if a smart card
application changes protocols, the smart card reader may continue
to try to communicate using the previous protocol. Use this setting
to override auto-detection of the communication protocol, if
necessary. You can select from the following options:
Disabled: No override, the smart card reader auto-detects the
protocol to use.
T0: Force the protocol to T=0 (asynchronous half-duplex byte
transmission).
T1: Force the protocol to T=1 (asynchronous half-duplex block
transmission protocol).
Default: Disabled
SmartcardForceShareMode Select from the following options:
Disabled
Exclusive
Shared
Direct
Default: Direct
Option Description
To Next Page
Loading...
Need help?
General
