DataCard SD260 - Ethernet Requirements; USB Requirements; Electrical Requirements

2 Installation
Ethernet Requirements
YoucanconnectmanynetworkprinterstoonePC.Themaximumnumberofprintersdependson
thecapacityofthenetworktodeliverdatatotheprinter.
ToinstallanSD260printeronanetwork,thefollowingcomponentsarerequired:
 AnEthernetnetworkthatusestheTCP /IPprotocolandcanrunat100megabitspersecond,
alsocalled100base‐T.Printersalsosupport10base‐T.
 AnEthernetcabletoconnecttheprintertothenetwork.AnEthernetcableisnotsupplied
withtheprinter.
 APCthatmeetsthe“PCRequirements”describedonpage 1,andisconnectedtoand
communicatingwiththenetwork.
USB Requirements
YoucanconnectuptoeightcardprinterstoaPCusingUSBcables.
ToinstallaprinterusingaUSBconnection,thefollowingcomponentsarerequired:
 Ahigh‐speedUSBport.USB2.0isrequired.
 AUSB2.0cabletoconnecttheprintertothePC.AUSBcableissuppliedwiththeprinter.
 APCthatmeetsthe“PCRequirements”describedonpage 1.
IfyouneedtoconnecttwocardprinterstoaPCwithoneUSBport,useasingle,independently
poweredUSBhubtowhichyoucanconnectbothprinters.
Electrical Requirements
Thepowersupplydetectstheinputvoltageandworkswithintherangestated.
PrinterModel
ElectricalRequirements
Input Output
SD160orSD260 110–240V/50–60Hz/1.5Amp 24V/3.0Amp/72W