Elrepho 3000
deleted. Please contact your Datacolor International Service
representative for further instructions.
INSTRUMENT DATA NOT LOADED
This message will be displayed if the instrument specific data is not
found during the power up procedure. This condition could occur if
this data was not loaded with the application program, or deleted.
Please contact your Datacolor International Service representative
for further instructions.
ILLUMINANT DATA NOT LOADED
This message will be displayed if the instrument’s illuminant data is
not found during the power up procedure. This condition could
occur if the illuminant data was not loaded with the application
program, or deleted. Please contact your Datacolor International
Service representative for further instructions.
MODEL DATA NOT LOADED
This message will be displayed if the instrument’s model data is not
found during the power up procedure. This condition could occur if
the model data was not loaded with the application program, or
deleted. Please contact your Datacolor International Service
representative for further instructions.
WARNING WHITENESS CAL SETUP INVALID - DEFAULTS
LOADED
INSTRUMENT SPECIFIC DATA MUST BE LOADED - PERFORM
CAL SETUP
This message will be displayed if the instrument’s Whiteness data is
not found or determined to be corrupted during the power up
procedure. This condition could occur if this data was not stored at
the factory or somehow became corrupted. Since this data is
instrument specific, you must be sure to load this data into the
instrument or else improper measurement results could result.
Default data is loaded so that the system can continue to function.
Once the default data has been loaded, no further messages will be
displayed to remind you this data needs to be updated, therefore you
should load the instrument specific data shipped with the instrument
as soon as possible. Please contact your Datacolor International
Service representative for further instructions.
Datacolor International
57
To Next Page
Loading...
