Elrepho 3000
MUST SELECT STANDARD BEFORE SAVING
This message will be displayed when attempting to save a job
before a standard has been selected. Standards are not required by
all jobs. If the procedure contains task’s which require comparison
to a standard, then one must be selected for the job before it can be
saved. Select the standard which should be used with the job.
BASIS WEIGHT MUST BE GREATER THAN ZERO
This message will be displayed when attempting to save a job with
a paper basis weight of zero. Enter a weight which is greater than
zero.
CAN NOT SAVE WITHOUT ANY TASKS
This message will be displayed when attempting to save a
procedure with no tasks associated with it. All procedure’s must
have at least one task associated with them. Select at least one task
to use with the procedure before attempting to save the procedure.
MAX TASKS ADDED
This message will be displayed when attempting to create a
procedure after there have already been 20 stored in the file system.
Due to limitations in the memory system, a maximum of 20
procedures can be stored at any one time. Use the “Data
Maintenance” option on your Setup Menu to delete unnecessary
procedures to make room for new procedures.
CAN NOT CREATE PROCEDURE NO TASKS EXIST
This message will be displayed when attempting to create a
procedure before any tasks has been defined. All procedure’s must
have at least one task associated with them. Define tasks before
attempting to create new procedures.
PLEASE STANDBY INITIALIZING SYSTEM
This message is displayed when the instrument is first powered on.
It remains on the screen while several hardware devices are
initialized. This message is for informational purposes only and
does not indicate any problems with the instrument.
Datacolor International
59
To Next Page
Loading...
