Elrepho 3000
Password Setup Mode
This mode is used for the following functions:
• Enabling a password
• Disabling a password
• Setting the password
Appendix B: Password Protection
Password Setup Mode (cont)
You enter the mode by starting the instrument while holding down
the second key from the right. Once in this mode, the screen will
indicate the current status, i.e., whether or not password protection
is currently enabled. A prompt message will be displayed indicating
that a new password should be entered.
While in this mode, the rightmost key label will change depending
on how many password keys have been pressed. Before any
password keys are pressed, the key will be labeled to indicate that
pressing the key will disable password protection.
Once you press any password “digit” key, the key will be re-labeled
to indicate that when you press the key the password will be saved
and you enter the Password Setup Verification Mode. This method
allows the number of characters to vary.
You can press the MENU key at any time to exit the Password
Setup Mode without saving changes.
Password Setup Verification Mode
This mode will require that you re-enter the new password to verify
that it has been properly defined. When you enter this mode, a
prompt message will be displayed indicating that the password must
be re-entered for verification purposes.
66 Datacolor International
To Next Page
Loading...
