Datakom DKM-411 - Gsm Modem Parameters

DKM-411 User Manual Rev_01 Firmware V-1.0
K46D03-EN - 72 -
Parameter Definition
Description
APN User Name
The APN (access point name) username may be required by the GSM
operator. However some GSM operators may allow access without
username.
The exact information should be obtained from the GSM operator.
Please search the GSM operator’s website with “APN” string.
APN Password
If the APN (access point name) username is required by the GSM
operator, most probably the APN password will also be required. However
some GSM operators may allow access without password.
The exact information should be obtained from the GSM operator.
Please search the GSM operator’s website with “APN” string.
APN Name
The APN (access point name) is always required by the GSM operator.
The exact information should be obtained from the GSM operator.
Please search the GSM operator’s website with “APN” string.
SMS Service Center
Number
The SMS service center number may be required by the GSM operator.
However some GSM operators may allow SMS sending without SMS
service center number.
The exact information should be obtained from the GSM operator.
Please search the GSM operator’s website with “sms service center” string.
Parameter Definition
Unit
Min
Max
Factory
Set
Description
Modem Selection
-
0
1
0
0: not used
1: external GSM Datakom modem
SMS Enable
-
0
1
0
0: SMS messages disabled
1: SMS messages enabled
GPRS Connection
Enable
-
0
1
0
0: GPRS disabled
1: GPRS enabled
SMS on Output Change
-
0
1
0
This parameter controls SMS
sending when any output has
changed state. No warnings
generated.
0: no SMS on output change
1: SMS sent on output change
SMS on IP Change
-
0
1
0
0: no SMS on IP address change
1: SMS sent on IP addresschange
SMS Commands
Enabled
-
0
1
0
0: SMS commands not accepted
1: SMS commands are accepted but
from listed telephone numbers only.
Below GSM modem related parameters are found in the
Controller Configuration group.
20.12. GSM MODEM PARAMETERS