Datakom DKM-411 - Page 74

DKM-411 User Manual Rev_01 Firmware V-1.0
K46D03-EN - 74 -
Parameter Definition
Factory Set
Description
Mail Account Name
d500_a
This is the account name appearing in the “from” tab
of the e-mail recipient. (ex: datakom-d500@gmail.com)
Mail Account
Password
d500_1234
This is the e-mail password of above e-mail account.
Mail Server Address
smtp.mail.yahoo.com
This is the Outgoing Mail Server Address of the above
e-mail account (ex: smtp.gmail.com)
E-mail Address-1
E-mail Address-2
E-mail Address-3
-
-
-
These are e-mail recipient addresses where the unit is
intended to send e-mail messages. Up to 3 e-mails can
be sent at once.
Parameter Definition
Unit
Min
Max
Factory
Set
Description
Web Refresh Rate
sec
0
240
5
The unit will refresh the web page with
this interval.
Ethernet Enable
-
0
1
1
0: ethernet port disabled
1: ethernet port enabled
E-mail on IP Change
-
0
1
0
0: no e-mail on IP change
1: e-mail sent on IP change
Ping Period
sec
30
900
120
The unit will check the availability of
the internet connection with this
interval.
Rainbow Scada Refresh
Rate
sec
0
65535
60
The unit will update the distant
monitoring terminal with this rate.
Rainbow Scada
Address-1 Port
-
0
65535
90
This is the port number of the first
monitoring terminal address.
Rainbow Scada
Address-2 Port
-
0
65535
90
This is the port number of the
second monitoring terminal address.
Web Server Port
-
0
65535
80
This is the port number of the
internal web server. The unit will
answer queries to this port only.
Modbus TCP/IP Port
-
0
65535
502
Internal Modbus TCP/IP server’s port
number. The unit answers Modbus
requests to this port only.
SMTP Port
-
0
65535
587
Port number used for e-mail sending.
20.13. ETHERNET PARAMETERS (continued)
Below ETHERNET related parameters are found in the
Controller Configuration group.