Datalogic Gryphon I GD4400

Enter/Exit Programming Mode
Product Reference Guide 111
Stand Operation
Specifies the behavior of the reader when stationary in a stand. There are two
conditions which cause the reader to switch to Stand Mode:
1. The reader is configured to switch
to Stand Mode when stationary.
2. The reader is placed into the cradle of the base station.
Below are further options concerning Stand Operation.
Ignore Autorecognition. Disables mode switching when the reader is placed in a
stand.
Switch to Stand Mode. Automatically switches the reader to Stand Mode when the
reader is placed in the stand.
Switch to Flashing. Automatically switches the reader to Flash Mode when the
reader is placed in the stand.
Switch to Always On. Automatically switches the reader to Always On mode when
the reader is placed in the stand
.
$CSMSD00(
CR)
Do Not Change Mode
$CSMSD01(
CR)
Change to Stand Mode
DEFAULT
$CSMSD02(CR)
Change to Always On
$CSMSD03(CR)
Change to Flashing