MATRIX 400™ CODE QUALITY VERIFIER SOLUTION
4
• ISO-IEC Modulation
• ISO-IEC Min Edge Contrast
• ISO-IEC Decodability
• ISO-IEC / AIM DPM Minimum Reflectance
• ISO-IEC Defects
• ISO-IEC / AIM DPM Decode
AIM DPM Threshold
This parameter is available when the AIM DPM Status parameter is enabled.
It defines the grade threshold for the AIM DPM code quality parameter(s) selected in Code
Quality Index, selected in Code Quality Index, under which the code will be filtered. A code
presented to the reader which has a code quality parameter grade lower than that specified
in this parameter will cause the code to be filtered (not collected).
The valid code quality parameters for this standard are:
• ISO-IEC / AIM DPM Overall Grade
• ISO-IEC / AIM DPM Axial Non Uniformity
• ISO-IEC / AIM DPM Unused ECC
• ISO-IEC / AIM DPM Fixed Pattern Damage
• ISO-IEC / AIM DPM Grid Non Uniformity
• ISO-IEC / AIM DPM Minimum Reflectance
• ISO-IEC / AIM DPM Decode
• AIM DPM Cell Contrast
• AIM DPM Cell Modulation
AS9132 (Parameter not visible)
AS9132 parameters are calculated on Pass/Fail basis: when AS9132 Status parameter is
enabled, a code presented to the reader which has at least one of the selected code quality
parameter grades equal to Fail will cause the code to be filtered (not collected).
The valid code quality parameters for this standard are:
• AS9132 Dot Size/Cell Fill
• AS9132 Dot Center Offset
• AS9132 Dot Ovality
• AS9132 Quiet Zone
• AS9132 Angle Of Distortion
• AS9132 Symbol Contrast
66
To Next Page
Loading...
Need help?
General
