Datalogic Memor - Page 56

1 DATALOGIC MEMOR™
48
4
BeepFrequency: determines the frequency in Hertz of the beeper.
GoodReadSound: is the beep sound emitted when the scanner reads a code.
LedDuration: the length of the good-read led pulse, in milliseconds.
LedPulses: the number of times the good-read led pulse is emitted when the
scanner reads a code.
ContinuousMode: disables the effect of the ScanTimeout parameter.
KeyboardEmulation: if enabled all scanned data are transformed into keyboard
events and can therefore be displayed and saved to a file as if input from the mobile
computer keyboard.
SoftTrigger: when enabled, the laser can be turned on/off by the application
software.
ScanAlwaysOn: enables the scanner for barcode reading independently from the
application software.
GreenSpotDuration: determines the duration (measured in milliseconds) of the
green spot feedback, which provides a “good read” green dot directly on the code,
where the operator usually tends to be looking.
NotPrintableChar: if set to “Remove”, all not printable characters included in the
scanned data are deleted and the final barcode will include only printable characters.
ScanButton: enables/disables the scan button. If the scan button is disabled, the
reader can be triggered under software control.