EasyManuals Logo

Datalogic Memor User Manual

Datalogic Memor
138 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #55 background imageLoading...
Page #55 background image
USE AND FUNCTIONING
47
4
Selecting Data Capture Setup Parameters
Alternatively using the stylus, you can tap once directly on the value on the right
column; continue tapping until the desired value is reached.
To activate a new configuration select the File ->Save Menu to send the new
configuration to the barcode decoding software and save the new configuration. This
will save the configuration to non-volatile memory preventing loss at the next system
reset.
Reader Parameters
The barcode reading parameters and values are dependent upon the type of scanner
module mounted in your mobile computer. For a detailed list of parameters and of
their configuration procedures, please refer to the SDK Help file on the CD.
Scan Parameters
The Scan Parameters are common to all scanner modules and allow control of the
scanning device. The Scan parameters are described as follows:
ScanTimeout: the maximum time, in milliseconds, during which the scanner remains
on without decoding any barcode.
BeepType: if set to dual tone, the good read beep is a sequence of high and low
pitch sounds. If set to monotone, the beep is a single pitch sound.
BeepDuration: the time interval, in milliseconds, during which the beeper will sound
when the scanner reads a code. To disable the beeper, set this value to 0.

Table of Contents

Other manuals for Datalogic Memor

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Datalogic Memor and is the answer not in the manual?

Datalogic Memor Specifications

General IconGeneral
Scan speed104 sec/page
Wavelength630 nm
Sensor typeLaser
Decoding standardsUPC A, UPC E, EAN 8, EAN 13, Code 39, Code 39 Full ASCII, Code 32, Interleaved 2 of 5, Industrial 2 of 5, Matrix 2 of 5, Code 128, EAN 128, Codabar, MSI, Plessey, Code 93, Code 11, GS1 Databar.
Product colorBlack
Internal memory256 MB
Built-in processorPXA310
Display resolution240 x 320 pixels
Processor frequency624 MHz
BluetoothYes
Standard interfacesUSB, RS-232
Battery typeLi-polymer/Li-ion
Input voltage5 V
Power consumption1100 mA
SafetyClass 2
DisplayReflective TFT 64K
Dimensions (WxDxH)152 x 55 x 40 mm
Storage temperature (T-T)-20 - 70 °C
Operating temperature (T-T)0 - 50 °C
Weight and Dimensions IconWeight and Dimensions
Weight230 g

Related product manuals