Datalogic Memor - 2 Batteries and Maintenance; 2.1 Charging the Battery Pack

BATTERIES AND MAINTENANCE
9
2
2 BATTERIES AND MAINTENANCE
Rechargeable backup batteries and battery packs are not initially
fully charged. Therefore the initial operation to perform is to charge
them. See below.
NOTE
Annual replacement of rechargeable battery pack avoids possible
risks or abnormalities and ensures maximum performance.
CAUTION
2.1 CHARGING THE BATTERY PACK
The battery pack autonomy varies according to many factors, such
as the frequency of barcode scanning, RF usage, battery life,
storage, environmental conditions, etc.
NOTE
The battery icon on the Taskbar indicates when the battery pack is low.
It is possible to recharge the battery pack by connecting the power supply directly to
the Datalogic Memor.
Alternatively, it is also possible to recharge the battery pack by inserting the
Datalogic Memor into the single slot dock or the multi battery charger.
Moreover recharging is possible by USB Direct connection with the host computer,
but with longer charging times and only if the mobile computer off.
During the charging process the LED positioned at the right side of the display is red
constant. Once the charging process has been completed this LED is green constant
(see par. 4.4).
The stand alone battery pack may be recharged outside a Datalogic Memor using the
spare battery charging slot on the back of the single slot dock or the multi battery
charger.