1 DATALOGIC MEMOR™
5. Press the Enter key or tap the screen to accept the new calibration settings.
Press the Esc key to keep the old settings.
New calibration settings are persistently saved in the Registry.
Startup Stylus Calibration
When starting the terminal, a stylus calibration screen comes up if valid calibration
settings are not available. This happens in the following circumstances:
1. At the first startup of the terminal.
2. After restoring registry default settings using the applet Registry Admin and
performing a warm boot.
3. After a Clean Boot.
4. After a Firmware Update (see section 4.8.3)
To Next Page
Loading...
