To Next Page

To Previous Page

Enter/Exit Programming Mode

206

PowerScan™ PD9530/PBT9500/PM9500

Motion Sensitivity

Defines discrete set of levels for scanner motion sensitivity when in hand-

held use.

$CMOSY00(CR)

Motion Sensitivity = Low

$CMOSY01(CR)

Motion Sensitivity = Medium

DEFAULT

$CMOSY02(CR)

Motion Sensitivity = High

Motionless Timeout

Specifies the waiting time in 100 millisecond ticks to assume that the reader

is in a motionless condition. The selectable range is 500 msec to 25.5 Sec-

onds. When no motion event is detected for a period of time longer than this

timeo

t, the software assumes the reader is in a motionless condition. This

option relates to such features as Aimer On and Stand Mode Object Sense

scanning with respect to motion. See "

Moti

onless Timeout" on page 287

References.

$CMOTO

Select Motionless Timeout Setting

To configure this feature, scan the ENTER/EXIT

PROGRAMMING MODE bar code above, then the bar

code at left followed by three digits from the Alpha-

numeric characters in

Appendix D, Keypad

rep-

resenting your desired character(s). End by scanning

the ENTER/EXIT bar

code again.

Make a mistake? Scan the CANCEL bar code to abort

not save the entry string. You can then start

again at the beginning.

CANCEL

DEFAULT

020 = Motionless Timeout = 2 seconds

Datalogic PowerScan 9500 Series User Manual

Questions and Answers: