Datalogic PowerScan 9500 Series User Manual

Enter/Exit Programming Mode
252 PowerScan™ PD9530/PBT9500/PM9500
Set String ID
Sets the identifier of the predefined strings.
$CPWEB
Set String ID
To configure this feature, scan the ENTER/EXIT PRO-
GRAMMING MODE bar code above, then the bar code
at
left followed by 6 digits from the Alphanumeric
characters in
Appendix D, Keypad .
The ID characters must be represented by their
hexa-
decimal ASCII code; if the first 2 digits are 0, this fea-
ture is disabled. End by scanning the E
NTER/EXIT bar
code again.
Make a mistake? Scan the CANCEL bar code to
abort
and not save the entry string. You can then start
again at the beginning.
~
CANCEL
Set String Header
Sets the header of the predefined strings.
$CPWED
Set String Header
To configure this feature, scan the ENTER/EXIT PRO-
GRAMMING MODE bar code above, then the bar code
at
left followed by 32 digits from the Alphanumeric
characters in
Appendix D, Keypad .
The digits must be the hexadecimal ASCII representa-
tion of the desired characters. If less than the
ex
pected string of 16 characters are selected, scan the
ENTER/EXIT bar code to terminate the string.
If the first 2 digits are 0, the feature is disabled. End
by scanning the ENTER/EXIT bar code again.
Make a mistake? Scan the CANCEL bar code to
abort
and not save the entry string. You can then start
again at the beginning.
~
CANCEL

Datalogic PowerScan 9500 Series Specifications

General

Brand	Datalogic
Model	PowerScan 9500 Series
Category	Barcode Reader
Language	English