Datalogic PowerScan 9500 Series

Enter/Exit Programming Mode
216 PowerScan™ PD9530/PBT9500/PM9500
Erase Batch Memory
When the scanner is configured in Manual Batch Mode, use the following bar
code to erase any labels stored in batch memory.
BatchClear
Erase Batch Memory
Do not scan an ENTER/EXIT PROGRAMMING MODE label in conjunc-
tion with this bar code.
RF Batch Mode Transmit Delay
Specifies the delay in 10 msec increments between transmitting labels
stored in batch memory.
DEFAULT
$CBTTD00(CR)
RF Batch Mode Transmit Delay = No Delay
$CBTTD05(CR)
RF Batch Mode Transmit Delay = 50 mS
$CBTTD0A(CR)
RF Batch Mode Transmit Delay = 100 mS
$CBTTD32(CR)
RF Batch Mode Transmit Delay = 0.5 seconds
$CBTTD64(CR)
RF Batch Mode Transmit Delay = 1 second
$CBTTDFA(CR)
RF Batch Mode Transmit Delay = 2.5 seconds