Enter/Exit Programming Mode
42
PowerScan™ PD9530/PBT9500/PM9500
Wedge Quiet Interval
Specifies amount of time to look for keyboard activity before scanner breaks
keyboard connection in order to transmit data to host. The selectable range
for this setting is 00 to 990 milliseconds (00-0x63 by 01) in increments of
ten milliseconds.
See page 264 in “References” for detailed information and
examples for setting this feature.
Set Wedge Quiet Interval
To configure this feature, scan the ENTER/EXIT
PROGRAMMING MODE bar code above, then
the bar code at left followed by the digits from
the Alphanumeric characters in
Appendix D,
Keypad
representing your desired character(s).
End by scanning the ENTER/EXIT bar code
agai
n.
Make a mistake? Scan the CANCEL bar code to
abor
t and not s
ave the entry string. You can
then start again at the beginning.
0A = Quiet Interval is
100 milliseconds
Intercode Delay
Specifies the delay between labels transmitted to the host for this interface.
The selectable range for this feature is from 0 to 99 seconds.
See
page 266 in “References” for detailed information and examples for set-
ting this feature.
Set Intercode Delay
To configure this feature, scan the ENTER/EXIT
PROGRAMMING MODE bar code above, then
the bar code at left followed by the digits from
the Alphanumeric characters in
Appendix D,
Keypad
representing your desired character(s).
End by scanning the ENTER/EXIT bar code
agai
n.
Make a mistake? Scan the CANCEL bar code to
abor
t and not s
ave the entry string. You can
then start again at the beginning.
00 = No Wedge Intercode Delay
To Next Page
Loading...
Need help?
General
