Enter/Exit Programming Mode
Product Reference Guide
219
REAL TIME CLOCK (RTC) CONFIGURATION
Current Date
Sets the date of the internal Real Time Clock (RTC)
Set Current Date = YYMMDD
To configure this feature, scan the ENTER/EXIT PRO-
GRAMMING MODE bar code above, then the bar code at
left foll
owed by the digits from the Alphanumeric charac-
ters in
Appendix D, Keypad
representing your
desired character(s). End by scanning the ENTER/EXIT bar
code again.
Make a mistake? Scan the CANCEL bar code to abort
and not save the entry string. You can then start
again at the beginning.
CANCEL
Current Time
Sets the time of the internal Real Time Clock (RTC). HH = 24 hours format
Set Current Time =
HHMMSS
To configure this feature, scan the ENTER/EXIT PRO-
GRAMMING MODE bar code above, then the bar code at
left foll
owed by the digits from the Alphanumeric charac-
ters in
Appendix D, Keypad
representing your
desired character(s). End by scanning the ENTER/EXIT bar
code again.
Make a mistake? Scan the CANCEL bar code to abort
and not save the entry string. You can then start
again at the beginning.
To Next Page
Loading...
Need help?
General
