Datalogic PowerScan 9500 Series User Manual

Enter/Exit Programming Mode
218 PowerScan™ PD9530/PBT9500/PM9500
Source Radio Address Delimiter Character
This option specifies the delimiter character to be placed between the label
data and radio address when address stamping is enabled.
$CBTAD
Set Source Radio Address Delimiter Character
To configure this feature, scan the ENTER/EXIT PRO-
GRAMMING MODE bar code above, then the bar code at
left followed by the digits from the Alphanumeric charac-
ters in
Appendix D, Keypad representing your
desired character(s). End by scanning the ENTER/EXIT bar
code again.
Make a mistake? Scan the CANCEL bar code to abort
and not save the entry string. You can then start
again at the beginning.
~
CANCEL
DEFAULT
00 = No Delimiter Character
This feature only applies if "Source Radio Address Transmis-
sion"
on page 217 is enabled.

Datalogic PowerScan 9500 Series Specifications

General

Brand	Datalogic
Model	PowerScan 9500 Series
Category	Barcode Reader
Language	English