To Next Page

To Previous Page

Enter/Exit Programming Mode

250

PowerScan™ PD9530/PBT9500/PM9500

Action Configuration for Function Keys

Configure actions (up to three) for the function keys

Configure Actions for F1

DEFAULT

$CPWEV0000\r

F1 No Actions Configured

$CPWEV

Configures Action for F1

To configure this feature, scan the ENTER/EXIT PRO-

GRAMMING MODE bar code above, then the bar code

for the Function Key

you want to program. Next scan

4 digits from the Alphanumeric characters in

Appen-

dix D, Keypad

The first digit must be 0; the following 3 digits must

be configured accordi

ng to the CMD_ID numbers in

Table 26 on page 249

. End by scanning the

ENTER/EXIT bar code again.

Make a mistake? Scan the CANCEL bar code to

abort

and not save the entry string. You can then start

again at the beginning.

CANCEL

DEFAULT

$CPWET0000\r

F2 No Actions Configured

$CPWET

Configure Actions for F2