Product Reference Guide 25
RS-232 ONLY Interface
Use the programming bar codes in this section if modifications to the standard
RS-232 interface settings are necessary to meet your system’s requirements.
Additional settings which apply to both the RS-232 and USB interfaces are
available in Chapter 6, RS-232/USB-COM Interfaces.
RS-232 Standard Factory Settings
Reference Appendix B, Standard Defaults for a listing of standard factory set-
tings.
BAUD RATE on page 26 PARITY on page 29
DATA BITS on page 27 HANDSHAKING CONTROL on page 30
STOP BITS on page 28
To Next Page
Loading...
Need help?
General
