Set system time:
Up & Down to change values, Enter to
change fields, at last field Enter exits saving
new values
Set system date:
Up & Down to change values, Enter to
change fields, at last field Enter exits saving
new values
Primary Ethernet interface
(it is advised not to change this value)
DeviceNet node address
(only DeviceNet models)
Profibus node address
(only Profibus models)
supplementary Ethernet interface
(only Dual Ethernet models)
(it is advised not to change this value)
Format the Compact Flash Disk
Format and repair corrupted CF
Del log files (SC8000 compatibility)
Shows CF capacity, free and used space
Performs the Net-Autoset procedure: assigns
random addresses to all slave nodes
Prints Lonworks network statistics (not data),
to the enabled serial port
Resets Statistical Counters
The Address parameters may be set through Genius™, (see chapter 3 for details).
For software versions earlier than 4.20, Statistical Counters can be reset by pressing the
Setup Key.
To Next Page
Loading...
Need help?
General
