Datalogic SC6000 User Manual

ix
GUIDE TO INSTALLATION
The following can be used as a checklist to verify all the steps necessary to complete
installation of the SC6000 Controller.
1) Read all information in the section “Compliance” at the beginning of this manual.
2) Correctly mount the SC6000 using the bracket provided according to the information
in par. 2.3.
3) Connect the SC6000 Controller to the PWO by means of the appropriate accessory
cables (see par. 1.4).
4) Provide correct and complete system cabling through the PWO according to the
signals (Lonworks, encoder P.S., etc) necessary for the layout of your application.
(See subparagraphs under par. 2.4 and 2.5. See also the PWO Installation Manual).
5) Install the Genius™ configuration program onto a laptop PC from the CD-ROM
provided. Configure the SC6000 Controller by connecting this PC to the SC6000
Auxiliary port.
For configuration of a cluster of DS6000 family scanners, or DS8100A/DX8200A
scanners or both, see par. 3.2.
For configuration of a cluster of DS8100 or DX8200 scanners or both, see par. 3.3.
6) Execute the Backup procedure described in par. 4.1.
7) Exit the configuration program and run your application.
The installation is now complete.

Datalogic SC6000 Specifications

General

Brand	Datalogic
Model	SC6000
Category	Controller
Language	English