The last section summarizes the calibration status of each scanner.
--------------------------------------
SCANNERS STATE SUMMARY
--------------------------------------
Scanner E Calibrated and verified
Scanner F Calibrated and verified
Scanner J Calibrated and verified
Scanner K Calibrated and verified
Scanner L Calibrated and verified
Scanner M Calibrated and verified
Scanner N Calibrated and verified
Scanner O Calibrated and verified
Scanner Q Calibrated and verified
Scanner R Calibrated and verified
Scanner S Calibrated and verified
2.7.5 AutoNet Setup Mode
A special Cluster Auto Setup Procedure (CASP™) allows automatic address assignment of
the scanner cluster nodes. This operation can be performed by starting up the system while
pressing the SETUP key.
Auto Setup can be performed in Genius™, see Net-Autoset in par. 3.2.1.
To Next Page
Loading...
