EasyManuals Logo

Datamax A-4310 User Manual

Default Icon
302 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #89 background imageLoading...
Page #89 background image
Extended System-Level Command Functions
Class Series Programmer’s Manual 73
(NT) Network Setup This command configures the printer for an Ethernet connection. Each
octet must be zero-filled to be properly interpreted (e.g., an IP Address of 10.12.0.243 must be
sent to the printer as 010.012.000.243).
Value Parameter Interpretation Default Value
*
Da
Is Discovery (DHCP or Bootp), where a:
Y = Enable
N = Disable
Y
G yyy.yyy.yyy.yyy
Is the Gateway Address, where:
y = 0 to 9
000.000.000.000
I xxx.xxx.xxx.xxx
Is the IP Address, where:
x = 0 to 9
192.168.010.026
N xxx.xxx.xxx.xxx
Is the SNMP Trap Address, where:
x = 0 to 9
000.000.000.000
P xxxx
Is the Port number, where:
x = 0 to 9
9100
S yyy.yyy.yyy.yyy
Is the Subnet Mask, where:
y = 0 to 9
255.255.255.000
Ta
Is SNMP enable,
where a:
Y = Enable
N = Disable
Y
U xxx.xxx.xxx.xxx
Is the WINS2 Address, where:
x = 0 to 9
000.000.000.000
wa
Is WiFi enable, where a:
Y = Enable
N = Disable
N
W xxx.xxx.xxx.xxx
Is the WINS1 Address, where:
x = 0 to 9
000.000.000.000
Y xxx.xxx.xxx.xxx
Is the DNS1 Address, where:
x = 0 to 9
000.000.000.000
Z xxx.xxx.xxx.xxx
Is the DNS2 Address, where:
x = 0 to 9
000.000.000.000
* Prior to the introduction of WiFi, 192.0.0.192 was the IP default value and the Subnet Mask was 0.0.0.0.
Table 5-5: Network Setup

Table of Contents

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Datamax A-4310 and is the answer not in the manual?

Datamax A-4310 Specifications

General IconGeneral
BrandDatamax
ModelA-4310
CategoryPrinter
LanguageEnglish

Related product manuals