To Next Page
C
colemanvernonSep 12, 2025
Why is my Datamax A-Class A-6310 feeding erratically?
- BBryce QuinnSep 12, 2025
If your Datamax Label Maker is feeding erratically, calibration may be needed. To calibrate, press and hold the FEED Key.
Why is my Datamax A-Class A-6310 feeding erratically?
If your Datamax Label Maker is feeding erratically, calibration may be needed. To calibrate, press and hold the FEED Key.
Why Intellifont™ will not print on Datamax Label Maker?
If Intellifont™ will not print on your Datamax Label Maker, you may be using an incorrect type. Intellifont™ format is Little/Big Endian specific and the printer uses Big Endian. Refer to your font supplier for information.
General| Print Resolution | 300 dpi |
|---|---|
| Print Speed | 10 ips |
| Memory | 16 MB DRAM, 8 MB Flash |
| Print Method | Thermal Transfer |
| Maximum Print Length | 99 inches |
| Connectivity | Serial, Parallel, USB |
| Supported Media Types | Labels, Tags |
| Media Thickness | 0.0025" (0.0635 mm) – 0.010" (0.254 mm) |
| Operating Temperature | 41°F to 104°F |
| Power Requirements | 100-240 VAC, 50-60 Hz |
Lists the standard features of the A-Class printer.
Instructions for safely unpacking the printer from its shipping carton.
General guidelines and requirements for installing the printer.
Details dimensions and hole locations for mounting the printer.
Explains how to connect the printer to a host system via various ports.
Details requirements and pinouts for parallel port connections.
Step-by-step guide for loading media into the printer.
Instructions for positioning the media sensor based on media type.
Guide for loading, handling, and removing ribbon for thermal transfer printing.
Steps for performing quick calibration of the printer.
Menu options for performing diagnostic tests on printer components and options.
Ensures correct media detection and should be performed when Quick Calibration fails.
Step-by-step guide for calibrating the printer using standard samples.
Adjustments to ensure consistent print quality over various media types.
Adjusts the Leveling Cam for even pressure distribution with media less than full width.
Adjusts the Burn Line to achieve print conformance and aesthetic standards.
Step-by-step instructions for replacing the printer's printhead.
Details recommended maintenance supplies, schedules, and methods for the printer.
Procedures for cleaning the printhead to ensure optimal performance.
Describes the three levels of printer reset methods available.
Instructions for updating the printer's application program (firmware).
Procedures for updating the printer's boot loader program.
Helps resolve common printer problems by providing solutions.
Lists common problems without displayed messages and their solutions.
Explains printer messages and provides possible actions or solutions.
