Datamax E-Class Mark II - Cover; Introduction

Removal and Replacement
4-1
4.0 Introduction
This section details the removal and replacement of the printer parts.
CAUTION
f Wear a wrist strap and follow standard ESD prevention measures.
f Use extreme care near the Printhead; never use a sharp object on the surface.
f Never use a sharp object on the Platen.
; Note: The procedures below assume a printer empty of media and ribbon.
4.1 Cover
Removal:
1. Turn OFF and unplug the printer.
2. Open the cover then gently flex the side of the printer outward and remove the Cover from the
hinge.
Replacement:
1. Gently flex the side of the printer outward and then install the Cover onto the Hinge.