Removing the keyboard
NOTE: Before working inside your computer, read the safety information that shipped with your computer and follow
the steps in Before working inside your computer. After working inside your computer, follow the instructions in After
working inside your computer. For more safety best practices, see the Regulatory Compliance home page at www.dell.com/
regulatory_compliance.
Prerequisites
1. Remove the base cover.
2. Remove the battery (half-length) or the battery (full-length), whichever applicable.
3. Follow the procedure from step 1 to step 3 in Removing the hard drive.
4. Remove the wireless card.
5. Follow the procedure from step 1 to step 5 in Removing the heat sink.
6. Remove the I/O board.
7. Remove the solid-state drive/Intel Optane.
8. Remove the coin-cell battery.
9. Remove the system board.
Procedure
1. Remove the eight screws (M1.2x2.4) that secure the keyboard bracket to the palm-rest assembly.
2. Remove the 32 screws (M1.2x1.9) that secure the keyboard to the palm-rest assembly.
3. Lift the keyboard off the palm-rest assembly.
50
100 Removing the keyboard
To Next Page
Loading...
