Removing the power-adapter port
NOTE: Before working inside your computer, read the safety information that shipped with your computer and follow
the steps in Before working inside your computer. After working inside your computer, follow the instructions in After
working inside your computer. For more safety best practices, see the Regulatory Compliance home page at www.dell.com/
regulatory_compliance.
Prerequisites
1. Remove the base cover.
2. Remove the battery (half-length) or the battery (full-length), whichever applicable.
3. Follow the procedure from step 1 to step 3 in Removing the hard drive.
4. Remove the wireless card.
5. Remove the solid-state drive/Intel Optane.
6. Follow the procedure from step 1 to step 5 in Removing the heat sink.
7. Remove the system board.
Procedure
1. Remove the two screws (M2.5x4.5) that secure the power-adapter port bracket to the palm-rest assembly.
2. Lift the power-adapter port bracket off the palm-rest assembly.
3. Lift the power-adapter port from the slot on the palm-rest assembly.
4. Peel the Mylar off the power-button board.
5. Remove the power-adapter port cable from the routing guides on the palm-rest assembly and lift the power-adapter port
along with its cable off the palm-rest assembly.
48
96 Removing the power-adapter port
To Next Page
Loading...
