3. Remove the 3.5-inch hard drive.
About this task
The following images indicate the location of the wireless card and provides a visual representation of the removal procedure.
Steps
1. Lay the computer on the right side.
2. Remove the screw (M2x3) that secures the wireless card to the system board.
3. Slide and lift the wireless-card bracket off the wireless card.
4. Disconnect the antenna cables from the wireless card.
5. Slide and remove the wireless card at an angle from the wireless-card slot.
Identifier
GUID-01BF7E08-76E2-4C7E-89AC-D8336D473992
Status Released
Installing the wireless card
Prerequisites
If you are replacing a component, remove the existing component before performing the installation procedure.
Removing and installing components
29
To Next Page
Loading...
