2. Route the rubber grommets through the slots on fan and pull the rubber grommets until the fan snaps into position.
3. Connect the fan cable to the system board.
Next steps
1. Install the light bar.
2. Install the left-side cover.
3. Follow the procedure in After working inside your computer.
Identifier
GUID-2A6DAE1B-1FBE-40F9-8D46-40E8C3FBD267
Status Released
Memory modules
Identifier
GUID-50B70DE0-84DE-4AD1-BA49-C3C8A1F410F1
Status Released
Removing the memory modules
Prerequisites
1. Follow the procedure in Before working inside your computer.
2. Remove the left-side cover.
About this task
The following images indicate the location of the memory modules and provides a visual representation of the removal procedure.
26
Removing and installing components
To Next Page
Loading...
