4. Using the alignment post, align the screw hole on the hard-drive assembly with the screw hole on the chassis.
5. Route the power cable and data cable through the routing guides on the hard-drive assembly and connect the cables to the hard
drive.
6. Replace the screw (#6-32) that secures the hard-drive assembly to the chassis.
Next steps
1. Install the left-side cover.
2. Follow the procedure in After working inside your computer.
Identifier GUID-55DF0237-E5D4-4AE6-855C-4E8A9733E1EC
Status Released
Chassis fan
Identifier
GUID-1831E91D-8022-4BAA-9CA1-30B55F1BF67D
Status Released
Removing the chassis fan
Prerequisites
1. Follow the procedure in Before working inside your computer.
2. Remove the left-side cover.
3. Remove the light bar.
About this task
The following images indicate the location of the chassis fan and provides a visual representation of the removal procedure.
Steps
1. Lay the computer on the right side.
2. Disconnect the fan cable from the system board.
3. Gently pull the fan to release it from the rubber grommets.
24
Removing and installing components
To Next Page
Loading...
