Steps
1. Align the graphics card with the PCI-Express card connector on the system board.
NOTE: To install the NVIDIA GeForce RTX 2080 graphics card, rotate and install the graphics card.
2. Using the alignment post, connect the card in the connector and press down firmly. Ensure that the card is firmly seated.
3. Close the PCIE door.
4. Place the graphics-card support bracket that connects the graphics card.
NOTE: This step is applicable only for computers that are shipped with a graphics-card support bracket.
5. Route the cables through the routing guide on the graphics-card support bracket and connect the power cables to the graphics card.
Next steps
1. Install the right-side cover.
2. Follow the procedure in After working inside your computer.
Identifier
GUID-D99D5F9B-0FF3-406B-A51F-FFA061BB89EA
Status Released
Coin-cell battery
Identifier
GUID-AD775204-4DA1-428A-A736-11E8E7C7DD53
Status Released
Removing the coin-cell battery
Prerequisites
1. Follow the procedure in Before working inside your computer.
NOTE:
Before working inside your computer, read the safety information that shipped with your computer and
follow the steps in Before working inside your computer. After working inside your computer, follow the instructions
in After working inside your computer. For more safety best practices, see the Regulatory Compliance home page at
www.dell.com/regulatory_compliance.
CAUTION: Removing the coin-cell battery resets the BIOS setup program’s settings to default. It is recommended
that you note the BIOS setup program’s settings before removing the coin-cell battery.
2. Remove the left-side cover.
3. Remove the graphics card.
About this task
The following images indicate the location of the coin-cell battery and provides a visual representation of the removal procedure.
36
Removing and installing components
To Next Page
Loading...
