2. Lift the VR heat sink off the system board.
Identifier GUID-39948DB5-7968-443E-9BBA-BC632FB9F03F
Status Released
Installing the VR heat sink
Prerequisites
If you are replacing a component, remove the existing component before performing the installation procedure.
About this task
The following images indicate the location of the VR heat sink and provides a visual representation of the installation procedure.
Steps
1. Align and place the VR heat sink on the system board.
2. Tighten the captive screws that secure the VR heat sink to the system board.
Next steps
1. Install the left-side cover.
2. Follow the procedure in After working inside your computer.
Removing and installing components
49
To Next Page
Loading...
