Steps
1.
NOTE:
Note the orientation or the SATA connector marking on the hard drive to replace it correctly.
Place the hard drive into the hard-drive carrier and align the tabs on the carrier with the slots on the hard drive.
2. Slide the hard-drive assembly into the hard-drive cage until it snaps into place.
3. Connect the data cable and power cable to the hard drive.
Next steps
1. Install the left-side cover.
2. Follow the procedure in After working inside your computer.
Identifier
GUID-DFA3DF29-7400-460D-B0A6-B30544A46E4A
Status Released
3.5-inch hard drive
Removing and installing components
21
To Next Page
Loading...
