16. memory-module slot (DIMM2)
17. front LED cable connector (PWR SW)
Identifier GUID-EA979CC8-84EC-4827-86C4-C80A8C31F4BF
Status Released
Recommended tools
The procedures in this document may require the following tools:
• Philips screwdriver #1
• Flat-head screwdriver
• Plastic scribe
Identifier
GUID-CC648B28-FBF9-4A6F-BB11-4C6C2FA3D08A
Status Released
Screw list
NOTE: When removing screws from a component, it is recommended to note the screw type, the quantity of screws,
and then place them in a screw storage box. This is to ensure that the correct number of screws and correct screw type
is restored when the component is replaced.
NOTE: Some computers have magnetic surfaces. Ensure that the screws are not left attached to such surface when
replacing a component.
NOTE: Screw color may vary with the configuration ordered.
Table 1. Screw list
Component Secured to Screw type Quantity Screw image
Right-side cover Chassis #6-32 2
Light bar Chassis #6-32 1
3.5-inch hard drive Chassis #6-32 1
3.5-inch hard drive Hard-drive cage #6-32 4
Wireless-card bracket System board M2x3 1
Solid-state drive System board M2x3 1
Intel Optane System board M2x3 1
Power-supply unit Chassis #6-32 2
Power-supply unit Chassis #6-32 3
Ports bezel Chassis #6-32 1
12 Removing and installing components
To Next Page
Loading...
